|
Qmark®
Aztec Radiant Ceiling Panels
We are an authorized distributor for Qmark®.
|
Qmark AZTEC Radiant Heating Panels are designed to provide
comfort by warming the surfaces below the heaters just as the sun warms surfaces
through radiant energy. This heating process heats objects in a room
without having to bring the room air temperature up to the same level. These
panels are ideal for spot heating in high heat loss areas. Panels may be
installed side by side or individually above areas requiring additional heat.
If used as a sole source of heat, more heat will be felt while standing directly
under the panel. Although the heater contains thermal insulation, it will
operate more efficiently in well insulated rooms. Four or more inches of
insulation above an exposed ceiling will increase both comfort and economy.
The heaters are intended to be controlled by a remote wall mounted thermostat.
The thermostat should be located in the same room on a side wall. It should also
be above five feet above the floor, but not directly under the heater so that it
does not get warmed by the radiant heat. Heaters may be repainted.
Do not remove paint from heaters. The surface must be first be free of grease or
oil. Use only a thin brush-on coat of high quality pure acrylic water base
flat latex. An off-white will give better coverage. Do not paint
with aluminum, oil base, vinyl-latex or rubber-base latex paint.
T-Bar System
The heater panels are designed for installation in
T-Bar ceilings. (Hold down clips are included.)
In this picture 5 full 24" x 24" panels are visible next to each
other, replacing
ceiling tiles.
For installation on non T-bar ceilings, surface
or recess mounting frame kits are available.
 |
For complete or supplemental heating in commercial,
residential and institutional structures-new or remodeled construction of offices, classrooms, family rooms, bathrooms. . .whenever the utility and
comfort of radiant ceiling heating is desired. |
|
|
Aztec radiant ceiling panel applications as primary or
supplemental heat include...
-
Commercial building perimeters to neutralize
down-drafts over glass, enclosed outside walkways, and washrooms
- School locker rooms, cafeterias, laboratories and
classrooms
- Hospital burn and trauma areas, recovery and
examination rooms
- Residential isolated cold spots, above sliding glass
doors and floor to ceiling windows. |
|
|
Clean, gentle, comfortable heat that is ideal for
offsetting perimeter heat loss; saving substantial energy over other systems by
heating people and objects rather than all the air in a room or building. |
|
|
People are comfortable at lower room temperatures with a
radiant system than with a hot air convective system, comfortable in the 60's
rather than in the 70's. And lower thermostat settings can save hundreds of
dollars in energy bills each year. |
|
|
Aztec panels allow full usage of wall and floor space. No
noise. No moving parts. No maintenance. No ceilings, walls or drapes to clean.
No dried out air. |
|
|
A simple system, easy to install, easy to control room by
room without wasting energy needlessly heating unoccupied spaces. |
|
|
Supplied with 48"L x 1/2" diameter flex conduit |
|
|
|
In this picture the panel is in a surface mount
frame on the ceiling next to the window
| METAL:
Back - 24 Gauge Galvanized or Aluminized Steel.
Front - 22 Gauge Galvanized or Aluminized Steel.
Sides - Overlapping Front and Back. |
| WIRE:
Internal - 200C, 14 Gauge, Teflon insulated. External - Pig Tails with
48" of 1/2" flexible conduit and connector for J-Box. |
| ELEMENT:
The encapsulated cassette element delivers a uniform temperature
distribution over entire panel surface. |
| INSULATION:
Minimum 1 inch, 1 pound density, high temperature fiberglass. |
| SURFACE:
All ceiling and wall mounted panels are coated with unique crystalline
surface. Birch white finish. Average surface
temperature of 250F. |
| CRYSTALLINE SURFACE - The panel's unique
crystalline surface greatly enhances the radiant characteristics of
the heating panel.
Radiant output is in the 8-10 micron wavelength. This is ideal for comfort.
Human skin will absorb 99% of the radiant energy in these wavelengths. Humans
themselves radiate heat predominately in that micron
range. Without the panel's crystalline surface a panel will
be less radiant, operate at higher temperature and produce energy at shorter
wavelengths. |
| ELEMENT - Encapsulated cassette
heating element assures uniform temperatures and long life. |
| WIRING - For connection to the main
power supply, the heater is completely prewired including green ground wire,
with the lead wires housed in a 48-inch length of flexible metal conduit and
connector for JBox mounting. |
| UNIVERSAL HANGING CLIPS - All
radiant ceiling panels are supplied with COMBINATION EARTHQUAKE-BAR GRIP CLIPS as a standard feature.
These clips have holes for support chains or can be folded over the J-BAR to
reduce lateral movement. |
| CERTIFICATION AND SAFETY
FIRE RATING - Heating panels do not
have a fire rating, but construction is of fire retardant materials. Panels
normally are treated like light fixtures. If necessary, acoustical tile can be
placed on top of the panels.
HAZARDOUS AREAS - Heating panels do not have a
hazardous rating. |
Wiring Diagrams (Heaters Must be Properly Grounded):
Custom size engineered
panels and custom features are
also available: (Contact us)
|
Mounting Kits Delivery time for the following products: Typically
shipped in
1 working day or less. The transit time to
you depends on your
physical location and your selected UPS/FedEx
shipping method, the cost of which will be displayed in your shopping
cart. |
|
Item ID |
Catalog
# |
Description |
Price |
Click "Select" below to see the actual quantity in stock |
|
QMARK10015 |
QSF2424 |
Surface mounting kit for 24" x 24"
panels |
$95.55 |
 |
|
QMARK10007 |
QSF2448 |
Surface mounting kit for
24" x 48" panels |
$119.85 |
|
|
QMARK20186 |
QRF2424 |
Recess mounting kit for
24" x 24" panels |
$61.65 |
|
|
QMARK20187 |
QRF2448 |
Recess mounting kit for 24"
x 48" panels |
$75.53 |
|
|
Wall
Mount Thermostats: (Optional)
|
|
AUBE10010 |
TH115-A-240D |
Aube Tech. Double
Pole, 240V Programmable Line Voltage Thermostat. 3600W @
240V 15 Amp resistive 60 Hz 4 wires / DPST. 7-day programming,
pre-programmed, backlight. 4 wires / DPST |
$66.17 |
|
|
AUBE10003 |
TH106 |
Aube Tech. 120/240V, S.P.S.T., Programmable Line Voltage
Thermostat |
$63.67 |
|
|
WR10001 |
WR-65 |
1A65-641 SPST Thermostat, 40°F to 85°F, 22 amp 120/240V, 18 amp 277V, Single Pole, wall mount |
$26.35 |
|
|
WR10002 |
WR-66 |
1A66-641 DPST Thermostat, 40°F to 85°F, 22
amp 240V, 18 amp 277V, Double Pole (D.P.S.T., Includes off
position), wall mount |
$26.35 |
|
| AUBE10041 |
TH104-Plus |
SPST Digital Line Voltage Thermostat,
240V
with Backlight LCD. |
$60.90 |
|
| AUBE10005 |
TH104 |
SPST Digital Line Voltage Thermostat,
120/240V |
$56.70 |
|
|
AUBE10022 |
TH115-A-120S |
2000 W @ 120 V, 16.7 A - 7-day programming, pre-programmed,
backlight. 4 wires / SPST |
$66.17 |
|
|
WR10018 |
1E30-343 |
White-Rodgers
Low Voltage Thermostat for Room Heating |
$34.99 |
|
|
WR10009 |
24A06G-1 |
White Rodgers Dual Level-Temp Low Voltage Control Systems |
$107.35 |
|
|
AUBE10036 |
TH115-A-024T |
0.5 A @ 24 V - R, C, W. 7-day programming, pre-programmed,
backlight, low voltage |
$63.60 |
|
| FOST10001 |
VHC-15 |
Fostoria VHC-15 208/240Volt Solid
State Variable Voltage Device.
15 Amps |
$88.28 |
|
|
QMARK98319841025 |
TC1 |
Qmark Clear Plastic
Universal Lockable Thermostat Guard. Dimensions: 7"L x
4.28"H x 2.74"D. |
$52.20 |
|
Qmark® is a registered
trademark of Marley Engineered Products.
|
